#Interview_questions and answers in drive test :

#RF_Drive_Test_Engineer_Interview_Questions
PROUD ENGINEERING
Trust Me, I'm A TELECOM-ENGINEER ....
#Interview_questions and answers in drive test :

#Q.1: Please introduce the telecommunication/wireless system configuration.

GSM: MS-BTS-BSC-MSC
WCDMA:UE-NODEB-RNC-CN

#Q.2: Tell us 2G/3G(noun) parameter we often see in the testing ,explain it:

GSM:
RX Level (Received signal level):
-70dbm to -20dbm:good;
-70dbm to -80dbm:normal;
-80dbm to -90dbm:acceptable;
below -90:bad

RX Quality (Recieved signal quality):
0 to 4 :good; 
4 to 6 normal;
up 6 bad;

C/I: Carries power / Interface power
WCDMA:
RSCP: Recieved signal code power
-70dbm to -20dbm:good
-70dbm to -80dbm:normal;
-80dbm to -90dbm:acceptable;
below -90:bad

Ec/Io: Chip energy / Interface of other cell:
0 to -6:good;
-6 to -10: normal;
-10 to -12:acceptance;
below -12:bad.

#Q3: Introduce the testing for new site.

① On air or not；
② sector swap or not;
③ site coverage;inter handover;intra handover;
④ GPRS or hsdpa hsupa testing
⑤ video call testing(3G)
⑥ sms,mms testing

#Q.4: How to estimate the antenna /feeder cross during testing?

When we at the service cell coverage the rxlev is other cell’s .and the rxlev is weakly.
When we test ,target cell ,the sverce line connect to other cell.

#Q5.Please Analysis of Causes of call drop.

Poor coverage:
Coverage hole, dead zone, isolated island, uplink/downlink unbalance Coverage over shooting Signal attenuation.
Interference:
Internal interference, external interference and the equipment interference ; Strong downlink/ uplink  interference.
Parameter setting not proper:
Radio link timeout counter, handover, power control etc.
Handover failure:

#Q.6: Please Analysis of Causes of handover failure.

① missing neighbor or neighbor not defined
② parameter for the handover are not good
③ Interference

#Q.7: Introduce the software and test equipment you have used Software:

① TEMS product:TEMS9.1;8.14;8.03;
② Nemo
③ Probe1.5,probe1.4;probe1.3; assistant analysis
④ Mapinfo:9.0;8.5;7.0;
⑤ actix analysis

Test mobile:
sonyerrisson: k800i; k790i; z750i; w600; w995
Nokia: 6680; N70; N80
Motorola: V3XX

#Q.8: Introduce the mapinfo and googlearth.

① Check the site location from google earth or mapinfo
② check the entironment nearby the site and make a plan for the testing from google earth and mapinfo;
③ analysis the logfile from mapinfo.

#Q.9: how can analysis the logfile and make report.

① actix software analysis
② Tems software analsis
③ assistant software analysis
Check coverage,quality ,handover and Throughput and so on.

http://engineerhammad.blogspot.com/2015/10/rf-engineer-interview-questions.html?m=0

#هندسة_الاتصالات